FREDO6 SKETCHUP PLUGIN DOWNLOAD FULL

I am not sure I full understand the case, but apparently you would like that the SubDiv tool create several subdivision lines instead of one. The currently provided 'SubDivision' option is basically a regular 4-gon with 'inner radius = offset' and hence the proposed n-gon profile can be seen as a generalization of the existing option. This has been done in the below examples.ДЄs you can see with an 8-gon you already get a subdivided surface being 1.2% off a circle.

This can be easily achieved when setting the border edges to creased in SubD. In addition when subdividing a rounded corner, you may not want the whole object to shrink (which Catmull-Clark subdivision does by definition). But a regular n-gon as the profile is even better. In an earlier post I mentioned that a squircle with an exponent value of roughly 2.1 gives good results as well. Therefore it would be helpful, if FredoCorner could provide an option under the category 'SubDivision' to create profiles as regular N-Gons with the inner radius = offset. (the first and last segment of the n-gon are coplanar to the side faces of the cube) You get very close to a circle after subdivision, if you start with a regular n-gon where the Inner radius is the same as the offset. If subdivision shall generate something that is close to an arc with a given radius, then the control mesh to start with cannot be an arc with the same radius or a square.

Thomthoms SubD) to smooth a corner, then the subdivided corner in general is not an arc. When using Catmull-Clark subdivision (i.e.

Fredo6 sketchup plugin download